SEQanswers

SEQanswers (http://seqanswers.com/forums/index.php)
-   General (http://seqanswers.com/forums/forumdisplay.php?f=16)
-   -   bioedit vs blastn results (http://seqanswers.com/forums/showthread.php?t=59111)

kaps 05-31-2015 10:52 PM

bioedit vs blastn results
 
1 Attachment(s)
hello, I have blasted my contigs and obtained some hits with high percentage identities. I then retrieved the fasta files of those hits and computed sequence identity matrix using bioedit. I expected the results from both blastn and bioedit to be the same, but they are not. Is this proper? if Not, what could be the problem?

I have attached a doc showing results

GenoMax 06-01-2015 03:32 AM

What exactly are you trying to do?

Blastn hits are probably not full length (unless the sequences are very homologous from end-to-end). I assume you are importing sequences that are full length into bioedit and then aligning them with clustalW (which is now a global alignment instead of the local in Blast). That is probably the reason why your identity matrix is not showing values closer to 1.0.

kaps 06-01-2015 06:02 AM

hi,

My interest is to generate a Pairwise sequence comparison matrix.
the blastn hits include both full length and partial. Seq identity matrix I posted were generated without clustalw alignment. when I aligned only 3 long seqs out of the 12 seqs remained. Imagine the 9 were eliminated because of being short?,dissimilar?

GenoMax 06-01-2015 06:18 AM

Are these sequences of similar length? Are there repeats (internal)?

You may want to look at dot plots if you are trying to find similarities.

kaps 06-02-2015 05:37 AM

The sequences differ in length. I have not checked whether there are repeats. how do I check for repeats?

I will read about dot plots using the link provided.

thanks


All times are GMT -8. The time now is 09:36 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.