Tweet
Hello everyone,
I have been using R package "cummeRbund" for a while now (with not much of knowledge though), however, its until very recently that I am getting an error
"This data.table install has not detected OpenMP support. It will work but slower in single threaded mode."
Then when I check my gene of interest, like:
> myGene<-getGene(cuff_data,myGeneId)
It gives this error:
Warning messages:
1: Closing open result set, pending rows
2: Closing open result set, pending rows
I tried to use Rstudio installed on another mac, but also got the same error.
I never faced this problem before. Can anyone please suggest how to fix this and did it happen to anyone else as well??
Awaiting for your kind response, thank you
I have been using R package "cummeRbund" for a while now (with not much of knowledge though), however, its until very recently that I am getting an error
"This data.table install has not detected OpenMP support. It will work but slower in single threaded mode."
Then when I check my gene of interest, like:
> myGene<-getGene(cuff_data,myGeneId)
It gives this error:
Warning messages:
1: Closing open result set, pending rows
2: Closing open result set, pending rows
I tried to use Rstudio installed on another mac, but also got the same error.
I never faced this problem before. Can anyone please suggest how to fix this and did it happen to anyone else as well??
Awaiting for your kind response, thank you
Comment