Help on running Solid SAGE Analysis Software

[jinghanna]

I installed the SOLiD SAGE Analysis Software following the manual. After I typed "perl solid.sage.pl", one program screen popped up, as the manual suggested. But I could not enter anything, such as project name, project path, nor could I click any button except the "Exit" buttom, which is the only button that works.

Anybody met similar problem? How can I solve this? Any suggestions are highly appreciated!

Thanks a lot,
Jing

[aguffanti]

Jing, there is a command line version which you can get from support. Also did you check the rwx permissions on the filesystem you are using ? if you can not write on the disk the buttons will be disabled ...

Alessandro

[jinghanna]

Alessandro, thanks for your info.