View Single Post
Old 07-15-2015, 10:59 AM   #4
Senior Member
Location: East Coast USA

Join Date: Feb 2008
Posts: 7,083

Depending on how you schedule the runs (number of cycles, SE vs PE etc) the size of the original data folder will vary but you can expect it to be somewhere between these values (e.g. 50x7 ~12G to 300x8x8x300 ~60G). After demultiplexing (bcl2fastq) the size will increase by about 50% (so data folders would become ~18 to ~80G in above example). We don't use on-board MiSeq software, but I expect if you did that then the folder sizes would likely be similar to final sizes above.
GenoMax is offline   Reply With Quote