We are testing the Agilent stranded kit in the next couple of weeks. I'll try to get back to this thread to mention the outcome. Good to see ETHANol again.
Seqanswers Leaderboard Ad
Collapse
Announcement
Collapse
No announcement yet.
X
-
Originally posted by pmiguel View PostOr better, has anyone gone back to 50 minute incubations with SuperScriptII and then observed whether some of the strandedness of the resulting library is lost?
--
Phillip
Comment
-
Originally posted by ETHANol View PostThe original dUTP protocol required massive amounts of starting material because the ActD. If you removed ActD from the protocol you still got pretty good strandedness but required a lot less starting material. So my guess was that the Illumina stranded kit would give a lot lower yield. I'll find out today as I'll be using it for the first time. They do say that you can start out with 4 ug of RNA vs. 1 ug from the unstranded kit so that is some testament to lower efficiency. But I was thinking the yield was going to be a lot lower then that 4-fold difference in requested starting material suggested. From you experience that seems like the case.
I'm not sure why Illumina is recommending the same 15 cycles of PCR for both kits. In my experience with the unstranded kit that was way too many. I guess from your experience for that stranded kit that is more in the correct range.
Phillip sorry to hijack your thread a little, but how are you quantitating your libraries for pooling?
About pooling -- erg, sore subject. Well, we do a bioanalyzer chip first to make sure we have something and determine its size after amplification. Then we do qPCR on each of the components of the pool. Then we make the pool. Then we run another high sensitivity chip and do a final pool qPCR.
I think everything goes much smoother if your libraries are size selected on a gel and thus have a tight distribution. Clustering itself has this intense size bias, with the shortest amplicons seeming like they always cluster and the longest ones seeming like they never do. Correcting for that is unnecessary with tight bands, nearly impossible with wide ones. Well, speculation on my part entirely, though.
--
Phillip
Then we cluster at 15 pM. And... well we usually hit reasonable cluster densities on the flow cell. But frequently the spread on the number of reads for various components of the pool is 3x or higher.
Comment
-
Phillip, In my experience the ActD prevents DNA synthesis during first strand synthesis, but does not stop RNA synthesis. Haven't seen a significant difference between 15-50 minutes.
Noticed that TruSeq Stranded doesn't have a UDG step. Seems like they rely on their polymerase to not read through dUTP bases. Does anyone know what polymerase this is? Has anyone added the UDG step anyway and compared strandedness? I didn't understand this comment earlier in the thread, "No UDG step is required in Illumina protocol since they are ligating adapters first"
Originally posted by pmiguel View PostWe don't do additional cleanup, but since dUTP is not added until 2nd strand synthesis, no additional cleanup is actually needed.
The real problem to maintaining strandedness is just making sure the reverse transcriptase does no 2nd strand synthesis. As long as that does not happen, the libraries should be stranded.
BTW, we use this method now and it appears to work fine -- with the 15' RT incubation. No one seems to think that doubling that incubation time will result in RT doing DNA-templated polymerization.
Spec on the kit is 15 cycles of amplification. We used to typically use 8 cycles. But with the stranded kits we are going to 12-15 cycles. 15 cycles tends to take us about 10 nM, though.
But we scale back the Ampure cuts to mostly remove molecules with inserts smaller than 200 bp. So if the RT is not getting out that far in 15 minutes, that could be eating into our yields.
--
Phillip
Comment
-
Originally posted by MLog View PostHi all,
I started to use Illumina TruSeq Stranded mRNA kit: http://support.illumina.com/sequenci..._prep_kit.ilmn
and I noticed a couple of thing that puzzled me a lot.
First, the protocol for first strand synthesis suggested in the manual is 25C - 10 minutes, 42 C - 15 minutes and 70C 15 minutes. Only 15 minutes, is this really sufficient?
Is 15 minutes long enough. Well, we have made a bunch of libraries this way and they do work. However we noticed a recent decrease in yield with this kit. That is, previously we would get so much library that we cut back from 15 amplification cycles to 8. Now we tend to do 12-15 cycles.
However, it may well because of the issue you mention. The kit will have been optimized for typical RNAseq "counting" experiment. These are often done with single reads. So insert sizes beyond 100 nt are not needed. However we frequently do de novo transcriptomes. For these we think there is an advantage to using paired end reads and therefore want larger inserts.
With the old (non-stranded) kits, this was not an issue. As long as you reduced the fragmentation time, you could create cDNAs that were >2kb, if you wanted. (Well, you also needed to size select some how to get rid of the shorter insert stuff.)
But it could be that 15 minutes just does not get out to the distance we want.
Comment
-
Originally posted by Genohub View PostPhillip, In my experience the ActD prevents DNA synthesis during first strand synthesis, but does not stop RNA synthesis. Haven't seen a significant difference between 15-50 minutes.
Originally posted by Genohub View PostNoticed that TruSeq Stranded doesn't have a UDG step. Seems like they rely on their polymerase to not read through dUTP bases. Does anyone know what polymerase this is? Has anyone added the UDG step anyway and compared strandedness? I didn't understand this comment earlier in the thread, "No UDG step is required in Illumina protocol since they are ligating adapters first"
--
Phillip
Comment
Latest Articles
Collapse
-
by seqadmin
Despite advancements in sequencing platforms and related sample preparation technologies, certain sample types continue to present significant challenges that can compromise sequencing results. Pedro Echave, Senior Manager of the Global Business Segment at Revvity, explained that the success of a sequencing experiment ultimately depends on the amount and integrity of the nucleic acid template (RNA or DNA) obtained from a sample. “The better the quality of the nucleic acid isolated...-
Channel: Articles
03-22-2024, 06:39 AM -
-
by seqadmin
The field of conservation genomics centers on applying genomics technologies in support of conservation efforts and the preservation of biodiversity. This article features interviews with two researchers who showcase their innovative work and highlight the current state and future of conservation genomics.
Avian Conservation
Matthew DeSaix, a recent doctoral graduate from Kristen Ruegg’s lab at The University of Colorado, shared that most of his research...-
Channel: Articles
03-08-2024, 10:41 AM -
ad_right_rmr
Collapse
News
Collapse
Topics | Statistics | Last Post | ||
---|---|---|---|---|
Started by seqadmin, 03-27-2024, 06:37 PM
|
0 responses
14 views
0 likes
|
Last Post
by seqadmin
03-27-2024, 06:37 PM
|
||
Started by seqadmin, 03-27-2024, 06:07 PM
|
0 responses
13 views
0 likes
|
Last Post
by seqadmin
03-27-2024, 06:07 PM
|
||
Started by seqadmin, 03-22-2024, 10:03 AM
|
0 responses
53 views
0 likes
|
Last Post
by seqadmin
03-22-2024, 10:03 AM
|
||
Started by seqadmin, 03-21-2024, 07:32 AM
|
0 responses
70 views
0 likes
|
Last Post
by seqadmin
03-21-2024, 07:32 AM
|
Comment