Originally posted by pogaora
View Post
Unconfigured Ad
Collapse
X
-
If RNA-seq was strand-specific it may explain why you did not get any peak calls (if your peak caller requires peaks on both strands). You could perhaps calculate RPKMs and compare to the other samples, or compare SNP calls in exons to figure out where the reads come from...Originally posted by pogaora View PostWe haven't done any exome capture experiments, but there were RNAseq samples on the same flowcell. The picture shown is not typical of most genes though - even some which we know are highly expressed in these cells.
Bias may be different in ChIP and input since you start with less material in the ChIP library, but GC-bias will not result in such enrichments over exons.
Comment
-
-
Hi folks,
Is your target protein expected to bind to a single location (like a transcription factor)? or over a more distributed region?
If the former is true, I would suggest visualizing your read pile-up using the Broad's IGV which lets you look nicely at the strand-bias (Fig 1 here for an explanation of what I mean!). I've found this to be a great way visually inspecting the data for true binding sites vs. noise-peaks.
Cheers,
Lizzy
Comment
-
-
Hello again all. Thanks to everyone for their interest in this question.Originally posted by JohnK View PostI talked to a colleague who sees these exon-peak events in some of his data depending on what protein or transcription factor he's after. They could be perfectly valid.
Does the above mean that your colleague validated in the wet lab?
The peaks we're talking about are from targetting a transcription factor and we see reads on both strands in all of the peaks that were in the pic posted earlier.
Comment
-
-
Hi Pogaora,
We observed the same exon enriched peak patterns in our ChIP-seq datasets. We also tried another replicate but it didn't happen again. Can you reproduce such peak patterns? I'm interested in comparing your data with ours (we can provide our data too if you are interested). I've sent you a message about the details.
Best regards,
yxi
Comment
-
-
-
how should that work technically, mRNA getting fixed into the library? you have any experimental evidence?Originally posted by hon View PostIt may also due to RNAase treatment is not enough, so mRNA was carried over to library construction. Make sure RNAase treatment is done long enough, trace of RNA will be magnified in library.
Comment
-
-
I didn't have exact experimental evidence but that phenomenon also occurred to me once that many reads pile up on exons of some genes. My reason is that only mRNA mapped to exons, it was either due to mRNA contamination in the lab or ChIP sample was not completely RNAase treated. Since then, I paid careful attention to ChIP-seq library contamination, it didn't happen again.
Comment
-
Latest Articles
Collapse
-
by SEQadmin2
Data variability is still an issue in sequencing technologies despite the advances in reproducibility and accuracy of these platforms. But the problem does not originate in the sequencing itself, but in the previous steps, before the sample reaches the sequencer.
The first step is collection, followed by preservation and sample preparation for analysis. Most scientists overlook those steps, but not being careful might just be skewing the experiment’s results.
...-
Channel: Articles
06-02-2026, 10:05 AM -
-
by SEQadmin2
With the launch of new single-cell sequencing platforms in 2026, the field stands at an exciting inflection point. This article surveys the most impactful advances in the field and discusses how they’re reshaping research in cancer, immunology, and beyond.
Introduction
Single-cell sequencing technologies have undergone remarkable advances over the past decade, transitioning from low-throughput experimental approaches to highly scalable platforms capable of...-
Channel: Articles
05-22-2026, 06:42 AM -
ad_right_rmr
Collapse
News
Collapse
| Topics | Statistics | Last Post | ||
|---|---|---|---|---|
|
Sequencing the Two-Toed Sloth Genome Reveals Jumping Genes Tied to Its Extreme Metabolism
by SEQadmin2
Started by SEQadmin2, 06-09-2026, 11:58 AM
|
0 responses
17 views
0 reactions
|
Last Post
by SEQadmin2
06-09-2026, 11:58 AM
|
||
|
Started by SEQadmin2, 06-05-2026, 10:09 AM
|
0 responses
27 views
0 reactions
|
Last Post
by SEQadmin2
06-05-2026, 10:09 AM
|
||
|
Started by SEQadmin2, 06-04-2026, 08:59 AM
|
0 responses
37 views
0 reactions
|
Last Post
by SEQadmin2
06-04-2026, 08:59 AM
|
||
|
Started by SEQadmin2, 06-02-2026, 12:03 PM
|
0 responses
61 views
0 reactions
|
Last Post
by SEQadmin2
06-02-2026, 12:03 PM
|
Comment