SEQanswers

Go Back   SEQanswers > Sequencing Technologies/Companies > SOLiD



Similar Threads
Thread Thread Starter Forum Replies Last Post
EZ bead Bubbles after transfering emulsion asaleh SOLiD 1 06-20-2011 05:32 AM
Beads not sticking to slides pmiguel SOLiD 20 04-08-2011 12:40 PM
Slides for dessimination maasha General 0 10-01-2009 12:54 AM

Reply
 
Thread Tools
Old 10-13-2010, 05:54 AM   #1
pmiguel
Senior Member
 
Location: Purdue University, West Lafayette, Indiana

Join Date: Aug 2008
Posts: 2,300
Default Bubbles and XD slides

We recently had a case were our long mate pair library beads were looking great for the first tag (R3) but terrible for the second (F3). We were unable to finish the F3 run. In looking at the slide we found that most of our beads had been stripped off the slides in both flow cells.

The new, XD, deposition method/chemistry had been up to this point something of a disappointment for us. We were unable to get much past 500 million beads deposited on a slide -- far short of the 700 million that is specified in all marketing for the v4 instrument. Also, it seemed subject to strange artifacts near the injection ports -- circular areas that seemed scoured and were depleted in bead numbers.

But these issues paled in comparison to the problem described above. We were perplexed as to the source of our new issue. At first no answer seemed forthcoming. But then we began hearing that XD depositions are particularly susceptible to bubbles during a run. I am not clear on the nature of this susceptibility -- whether the bubbles just mechanically knock the beads off, or if they alter the bead linkage chemistry, leading to beads being washed off.

Either way, as long as the fluidics of the SOLiD remain more-or-less bubble free -- this should not be a problem. After this disastrous run failure, our service engineer ran a fluidics check for us and found an issue in an unexpected place. He visually confirmed that the lines were not pumping bubbles into the flow cells. Yet after fluidics that involved adding liquid from the storage buffer bottle, the flow cells consistently filled with bubbles.

This behavior went away when the cap for the storage buffer bottle (labeled "8b" in Appendix E of the System Instrumnet Operation Guide) was replaced. Our guess is that the fitting the connects the fluid tubing outside the storage buffer bottle to the straw that dips down into the storage buffer inside this bottle had somehow become clogged, and was therefore pulling a vacuum on the flow cells under some circumstances, causing air to be drawn in through the gaskets. This fit our observation that the first tag looked great, but the second tag was terrible because prior to the pause between tags, the instrument pumps storage buffer into the flow cells.

One could also imagine scenarios where this might crack slides were the gaskets to hold firm. For example, in cases where the ambient temperatures were a little higher, the gaskets might seal more effectively because they were less rigid. Then the sustained pressure differential across the glass slide might favor formation of slide cracks.

Something to keep in mind...

--
Phillip

Last edited by pmiguel; 10-13-2010 at 11:45 AM.
pmiguel is offline   Reply With Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off




All times are GMT -8. The time now is 06:31 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Single Sign On provided by vBSSO