Hi all,
I know that DESeq2 relies on using raw read countsd as input. However, I have the following question:
What if the read counts were already normalized using DESeq2? Is there a way to start the analysis after this step?
A colleague did an initial DESeq2 run on our data, and supplied a table with the normalized read counts from DESEq. I do not have the raw counts, and was wondering if I could start from here and skip the normalization method that DESeq perfoms.
I know that DESeq2 relies on using raw read countsd as input. However, I have the following question:
What if the read counts were already normalized using DESeq2? Is there a way to start the analysis after this step?
A colleague did an initial DESeq2 run on our data, and supplied a table with the normalized read counts from DESEq. I do not have the raw counts, and was wondering if I could start from here and skip the normalization method that DESeq perfoms.
Comment