Hello everyone,
I created pileup files from sam/bam files via Samtools.
For every reference in the alignment, the pileup entries start from the 5'-most reference position that is covered by reads.
How can I force Samtools to list the uncovered positions too?
Best regards,
SquirrelSeq
I created pileup files from sam/bam files via Samtools.
For every reference in the alignment, the pileup entries start from the 5'-most reference position that is covered by reads.
How can I force Samtools to list the uncovered positions too?
Best regards,
SquirrelSeq
Comment