Hello all!
I have a question about the command: maq indelpe. I am executing the command using:
maq indelpe maq indelpe /data/maqgene/genomes/elegans.bfa 1342068649.map
But I fail to get results. The .map file is from a paired-end run and is generated using MaqGene. If however I use the command:
maq indelsoa maq indelpe /data/maqgene/genomes/elegans.bfa 1342068649.map
it works fine, but I am more interested in the paired-end deletions. Of course it could be that there are no deletions detected, but how can I test if the indelpe call actually does what it should? In other words is there a test case or anything that I can use. Also does anyone know if the mapping file, because it was generated by MaqGene is maybe different which might cause problems?
Thanks for the help!
Robin
I have a question about the command: maq indelpe. I am executing the command using:
maq indelpe maq indelpe /data/maqgene/genomes/elegans.bfa 1342068649.map
But I fail to get results. The .map file is from a paired-end run and is generated using MaqGene. If however I use the command:
maq indelsoa maq indelpe /data/maqgene/genomes/elegans.bfa 1342068649.map
it works fine, but I am more interested in the paired-end deletions. Of course it could be that there are no deletions detected, but how can I test if the indelpe call actually does what it should? In other words is there a test case or anything that I can use. Also does anyone know if the mapping file, because it was generated by MaqGene is maybe different which might cause problems?
Thanks for the help!
Robin