Hi,
I'm working on my thesis work and I'm trying to run BFAST software for aligning FASTQ datasets. I'm getting error written below. and the command is;
> bfast fasta2brg -f filename
The error is;
________________________________________________________________
****************
Checking input parameters supplied by the user ...
Validating fastaFileName SRR035022_1.filt.fastq.
Input arguments look good!
****************
Printing Program Parameters:
programMode: [ExecuteProgram]
fastaFileName: SRR035022_1.filt.fastq
space: [NT Space]
timing: [Not Using]
******************
Reading from SRR035022_1.filt.fastq.
********************
In function "RGBinaryRead": Fatal Error[OpenFileError]. Variable/Value: SRR035022_1.filt.fastq.
Message: Could not open file for reading.
The file stream error was:: Value too large for defined data type
***** Exiting due to errors *****
_____________________________________________________________
I couldnt figure out what the problem is...
Can you tell me what I'm doing wrong ?
Thanks in advance...
I'm working on my thesis work and I'm trying to run BFAST software for aligning FASTQ datasets. I'm getting error written below. and the command is;
> bfast fasta2brg -f filename
The error is;
________________________________________________________________
****************
Checking input parameters supplied by the user ...
Validating fastaFileName SRR035022_1.filt.fastq.
Input arguments look good!
****************
Printing Program Parameters:
programMode: [ExecuteProgram]
fastaFileName: SRR035022_1.filt.fastq
space: [NT Space]
timing: [Not Using]
******************
Reading from SRR035022_1.filt.fastq.
********************
In function "RGBinaryRead": Fatal Error[OpenFileError]. Variable/Value: SRR035022_1.filt.fastq.
Message: Could not open file for reading.
The file stream error was:: Value too large for defined data type
***** Exiting due to errors *****
_____________________________________________________________
I couldnt figure out what the problem is...
Can you tell me what I'm doing wrong ?
Thanks in advance...