Tweet
bacterial wgs library loading on MiSeq v3 600 cycles
Just wondering how much wgs library (prepared by Nextera xt kit) should be loaded on MiSeq using v3 600 cycle kit. We tried two times, 20 pM and 14 pM, both runs yielded only ~7 gb (half of 15 gb). We did several amplicon libraries which were pretty good. Are there any tricks? Thank you very much in advance.
-
-
Your experience indicates issues with correct quantification and loading. For good yield cluster density should be over 1200k/mm2 and this can be achieved with18-19 pM loading.
For specific diagnosis you can contact Tech support at Illumine or post more information about library (trace), quantification method, if bead normalisation was used and run summary page from SAV.
-
Proteins are often described as the workhorses of the cell, and identifying their sequences is key to understanding their role in biological processes and disease. Currently, the most common technique used to determine protein sequences is mass spectrometry. While still a valuable tool, mass spectrometry faces several limitations and requires a highly experienced scientist familiar with the equipment to operate it. Additionally, other proteomic methods, like affinity assays, are constrained...04-04-2024, 04:25 PM -
Despite advancements in sequencing platforms and related sample preparation technologies, certain sample types continue to present significant challenges that can compromise sequencing results. Pedro Echave, Senior Manager of the Global Business Segment at Revvity, explained that the success of a sequencing experiment ultimately depends on the amount and integrity of the nucleic acid template (RNA or DNA) obtained from a sample. “The better the quality of the nucleic acid isolated...03-22-2024, 06:39 AM
Comment