|
|
|
|
|||||||
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SOLiD SAGE reads direction and orientation | invermay | SOLiD | 0 | 02-14-2011 07:17 PM |
| SOLiD SAGE v3 Analysis Software | DNAjunk | SOLiD | 19 | 02-14-2011 02:59 PM |
| SOLiD 3 - SAGE kit | DNAjunk | SOLiD | 5 | 01-05-2011 03:04 AM |
| Computer for running GS Junior Software | Martin Mikkelsen | 454 Pyrosequencing | 7 | 01-03-2011 05:37 PM |
| SOLiD SAGE: low percentage of reads mapped | rahilsethi | SOLiD | 0 | 09-09-2010 12:04 PM |
 |
|
|
Thread Tools |
05-08-2010, 11:48 AM
|
#1 |
|
Member
Location: San Jose Join Date: May 2010
Posts: 10
|
Help on running Solid SAGE Analysis Software
I installed the SOLiD SAGE Analysis Software following the manual. After I typed "perl solid.sage.pl", one program screen popped up, as the manual suggested. But I could not enter anything, such as project name, project path, nor could I click any button except the "Exit" buttom, which is the only button that works.
Anybody met similar problem? How can I solve this? Any suggestions are highly appreciated! Thanks a lot, Jing |
|
|
|
07-19-2010, 12:40 PM
|
#2 |
|
Member
Location: Milano, Italy Join Date: Dec 2008
Posts: 29
|
Jing, there is a command line version which you can get from support. Also did you check the rwx permissions on the filesystem you are using ? if you can not write on the disk the buttons will be disabled ...
Alessandro |
|
|
|
|
07-19-2010, 01:17 PM
|
#3 |
|
Member
Location: San Jose Join Date: May 2010
Posts: 10
|
Alessandro, thanks for your info.
|
|
|
|
|
| Thread Tools | |
|
|
