analyse illumina data

ptong7 · 10-30-2008, 02:26 AM

hi everyone,
i already got the illumina sequencing data, and i run the data on the MAQ.
now i have the result data as xxx.map file.
I dont know how to show the result on the browser .

is there anyone can tell me what kind programme i should use? where i can find it.

Thx,

P. Tong

ptong7 · 12-01-2008, 05:46 PM

hi everyone:
I already contact with the author who write the MAQ.
Now I know why I can’t open the map file in Maqview.
The MAQ, which I used was too new to the Maqview. If use the MAQ-0.6.8, I can open the map file in Maqview-0.2.4.
But unfortunately I still have some problem to show the result.

ECO · 12-01-2008, 05:50 PM

I have had problems with every version of maq other than 0.6.8. Just my two cents, I think a few others on here have expressed the same sentiments.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
small rna analyse	entomology	Bioinformatics	5	01-15-2012 07:04 AM
How to analyse time-series data with edgeR	ca85	RNA Sequencing	0	10-06-2011 05:04 AM
how to analyse alternative splice	blue mood	Bioinformatics	1	08-16-2011 09:17 PM
Analyse short reads using blast2go	rururara	Bioinformatics	1	04-12-2011 03:19 AM
Chip-seq analyse using USeq	VIB_user	Epigenetics	1	10-11-2010 06:06 AM

10-30-2008, 02:26 AM	#1
ptong7 Member Location: dublin Join Date: Oct 2008 Posts: 10	analyse illumina data hi everyone, i already got the illumina sequencing data, and i run the data on the MAQ. now i have the result data as xxx.map file. I dont know how to show the result on the browser . is there anyone can tell me what kind programme i should use? where i can find it. Thx, P. Tong

12-01-2008, 05:46 PM	#2
ptong7 Member Location: dublin Join Date: Oct 2008 Posts: 10	maqview hi everyone: I already contact with the author who write the MAQ. Now I know why I can’t open the map file in Maqview. The MAQ, which I used was too new to the Maqview. If use the MAQ-0.6.8, I can open the map file in Maqview-0.2.4. But unfortunately I still have some problem to show the result.

12-01-2008, 05:50 PM	#3
ECO --Site Admin-- Location: SF Bay Area, CA, USA Join Date: Oct 2007 Posts: 1,358	I have had problems with every version of maq other than 0.6.8. Just my two cents, I think a few others on here have expressed the same sentiments.